steevo99

4340, 2 1/2"dia, about 25" long. I gave just under $21 for the 4340, two 8" "c" clamps and some misc. sq. bar drops

I built a stand for my porta-band and I have to say it's the handiest! The last photo in the series reminds me: the lower guide bearings take a beating. Small pieces, grit etc all pass thru that slot in the top plate. Keep a set of replacement bearings and screws on hand.

JHCC, That's a clever hot cut!

Bravo Thomas

Good luck, my friend!

Speedy recovery. I owe you a cup of coffee

I like the Jim Coke solution, thin saw cut, rotate, weld etc. Been there but didn't done that. Thanks for the tip Jim

The semi-sharp edges remind me of an auger or maybe a gimlet. You could test by just running 1/4" or so drill bit into a cork an try to pull it out with a pair of vice grips. I like the lag bolt suggestion from SmoothBore

Great! Any chance of a few"under the hood" photos?

Here's one

After the reshaping of the head, would you harden and temper the fuller end?

Kind regards for your father in law, you and your family.

WOW, The MH anvil is an exact match to the one I have. Looks identical, same condition except for the teapot on the end of the bick. I bet you'll have that dressed in no time.

I'm always amazed at the creative part of re-purposing. Bravo!

I live some in NM, some in TN and one time my wife and I were eating breakfast at the only breakfast joint in town and ran into a German couple that came specifically for the Western/cowboy and Indian culture. We invited them out the house and an spent the day trading stories. They loved the local museums, the land and when they saw a cowboy w/spurs it was over. We have been swapping Christmas cards ever since. I'd like to know when that article hits the magazine, Rolf would get a kick out of it....so would I Steve.

Like BigGun, maybe....the cone is a tapered reciever of sorts. Pretty extreme taper though.

Beautiful! I pass through Muskogee quite often. I'd love to see one or two.

I agree! Dave's hammers are great. I bought one through the IFI promotion. I finally got to some serious anvil time this weekend. This was to be the " road test" but I ran into a small problem. My wife, who like to flatten things, barged in and took my new hammer and wouldn't turn loose. I tended the fire, barked instructions and waited until she got tired. After that, the road test! I love it. Thanks to IFI and Dave steve

Wiley Coyote look out! great

I have been using this. I'm really happy with level protection and fits under welding helmet too. http://www.millerwelds.com/products/welding_protection/filtration/half_mask/

Just another tripod

Sooo good!

good job. It gets right to the point

Great as always! What's the origin of the design?...historic, contemporary?

My first thought was about splitting, but it's nice and clean!