Brant
got to the top of the forum page and click user profile
click edit your details
enter your location and save.
We would like to know where in the world you are located.
1/2 inch cable here is handy to have to get vehicles out of ditches, from over embankments, etc., good for pulling trees out of the woods, all the stuff you use cable for anyway. If you don't have use for it, trade it for something of value to you.
We are now talking about carrying switchblade knives in two different countries with two different judicial systems, and the legal trouble it can cause.
The original question was
A warning would be appropriate to check local laws, and the local police intergeneration of those laws before making, carrying, or transporting this type of knife.
What are you doing to make your shop leaner and meaner in this time of rising costs?
Combining as many stops as possible into the same trip, the grocery store, the post office, the hardware store etc. Instead of using the rosebud and ox/ac gases, building a fire in the forge. Wearing the apron in order to save wear and tear (and dirt) on your clothes.
What are you doing to adjust to the rising costs?
Peter
go to the top of the forum page and click on user cp
click on edit profile
go to the bottom of the page, enter your location, and save.
We would like to know where in the world you are located.
Look at a smaller fan to supply air to the forge and a on/off switch for the fan. No use burning charcoal with a hurricane force wind when your not using the fire.
Try building a *boy scout* fire with sticks from the yard or wood kindling. Then add in the coal little at a time so the fire consumes the smoke. A forge hood and a tall chimney helps dilute any remaining smoke. With careful fire maintenance, build small hot fires, and you should be able to keep the smoke to a minimum.
scoobasteeve
go to the top of the forum page and click on user cp
click on edit profile
go to the bottom of the page, enter your location, and save.
We would like to know where in the world you are located.
Usually you can find something about "that" size. Stock size up to 3/8 inch round and 1/4 inch flat bar can be bent cold. With a little heat you can bend most any size.
There are several Blueprints on bending.
rfdecarter
go to the top of the forum page and click on user cp
click on edit profile
go to the bottom of the page, enter your location and save.
We would like to know where in the world you are located.
Stand the rr track on end. Use the 1 pound hammer more than anything else till you can locate a 2 pound hammer. A 3 pound hammer is a little heavy for most folks.
It is not the tools, but what you can do with them. When people look at what you have made, they don't ask if it was made from mild steel or 1060, or if you used a piece of rr steel or a 500 pound London pattern anvil. They ask about the price. And if the check clears the bank, you did a good job.
Mike, if they are your pix and your work, why not place them into the IForgeIron Gallery? If you add key words the photos become searchable and a valuable resource to others.
Squire
go to the top of the forum page and click on user cp
click on edit profile
go to the bottom of the page, enter your location, and save.
We would like to know where in the world you are located.
Alwin
go to the top of the forum page and click on user cp
click on edit profile
go to the bottom of the page, enter your location, and save.
We would like to know where in the world you are located.