ablenumbersix

Members
  • Content Count

    22
  • Joined

  • Last visited

About ablenumbersix

  • Rank
    Member

Profile Information

  • Gender
    Male
  • Location
    Orem, Utah

Recent Profile Visitors

The recent visitors block is disabled and is not being shown to other users.

  1. It's really too bad. I just got rid of my wagon tongue collection. I think I will use the bolts like Chris the Curious Said. https://www.iforgeiron.com/topic/54645-using-the-name-on-the-forum/
  2. I haven't decided how I'm going to mount it. If anyone has any good setups for this style of vise I'd love to see it.
  3. You're telling me. I wish I could find an approximate draw for it. I'll post a Pic of the full vise tomorrow.
  4. This vise only has half a maker's mark. Does anyone recognize it? I don't have a picture of the vise put together right now, but it's a wagon tongue vise.
  5. Can anyone tell me the general dimensions of a 300 lb fisher?
  6. When and where? well, I checked out the website like i should have done before i asked, and I'll be working...
  7. well I am a big fan of skulls and belt buckles, and I think its pretty xxxxxxxx cool...
  8. these are very cool. what is a cold shut, and how long have you been working metal?
  9. I would also point that when a person says asking X-amount/OBO, it usually means they are willing to settle for quite a bit less, but trying to start negotiations high. not always, but usually.
  10. he should have listed it as 8 hydroponic duct fans long... anyway, very beautiful anvil.
  11. I just sent off my membership request today. very excited.
  12. I promise to twist the next, but not at the handle.
  13. I'm sorry, I should have mentioned that I did not twist those, it was present in the scrap I used to make them. I don't even have a vise yet...
  14. I didn't follow any plans or anything, i just wanted to make something. so if something about the design doesn't make sense, that's because at this point i really don't know what I'm doing. also I found that my forge is too deep which is why I ran out of time in the first place. It's difficult to effectively heat something long, and will be until I cut a shallow spot into the side of my forge.