sidney brink

machine sleeve bearing to o d and I d cutout section.

i run a niles-bement pond lathe if that counts.

if you drill a small hole in the saw kerf the chips will have some place to go and you can saw steel as thick as inside of saw.

A 100 pound cylinder gives the liguid gas time to turn to vaper and not freeze up.

hello and welcome to ifi

hello welcome abord ifi.

Ice storm in arkansas to no power for 7 days .get out the camping gear .lite the wood stove in the crawl space under the house and let the heat rise through the floor.lanterns, dutchovens,gas water heater,but missed the tuesday night blue print.

I plumed the air in my shop with 1'' sch 40 pvc.25 years ago still working fine. I run 200 psi. Just allow room at each end of run for expansion . It gets longer when the shop warmes up.the first 10' is steel for heat build up.I have drop legs for moisture traps where they drop from ceiling hung main line.I also have second tank for more volume at far end of main to help large impact hammer.

I dip mine in cooking oil,wesson, at a black heat. this makes a nice black finish.used veggy oil is fine,and eddible for those cooking tools. can't raise bees highly alergic to them.

do they make safety glasses that are period corect ?????hum I wonder?????

very nice work.Being the hillbilly that I am, what size is a good size for a napkin ring?

I make my leaves by vaineing with a chisle[less tools to carry to demo,more variation].How do we access new bluprints if we miss the tuesday night showing?

a blueprint would take toooooooo long.how about some pointers here.I really like that oak leaf,great workmanship.

the brass hammer will leave brass on work though.

a sharp cutter in the hardy hole works with a brass hammer.spoons ,anything with an indentacion ,pipe end,large nut,bearing race,foot of anvil,mouse hole.

i'm a better blacksmith then computer button pusher.So I hope this comes out right.(if not it's going to be hard to throw in the scrap pile.)