yesteryearforge Posted December 4, 2012 Share Posted December 4, 2012 Quote Link to comment Share on other sites More sharing options...
Pug}{maN Posted December 4, 2012 Share Posted December 4, 2012 nice pice , hows the leg go on the shaft ? Quote Link to comment Share on other sites More sharing options...
yesteryearforge Posted December 4, 2012 Author Share Posted December 4, 2012 Rivetted tenon Quote Link to comment Share on other sites More sharing options...
ThomasPowers Posted December 4, 2012 Share Posted December 4, 2012 Beautifully done! You will be adding a lot more tools to it right? Quote Link to comment Share on other sites More sharing options...
John B Posted December 5, 2012 Share Posted December 5, 2012 Rivetted tenon Square or round? Countersunk, domed, or flush ? That about covers it. (Sorry, I couldn't resist) Quote Link to comment Share on other sites More sharing options...
K. Bryan Morgan Posted December 5, 2012 Share Posted December 5, 2012 John is channeling Thomas. :P Quote Link to comment Share on other sites More sharing options...
yesteryearforge Posted December 6, 2012 Author Share Posted December 6, 2012 Round , countersunk , and domed :) Quote Link to comment Share on other sites More sharing options...
ThomasPowers Posted December 6, 2012 Share Posted December 6, 2012 no I was going to add "with my off hand while inverted over a pit full of tigers"... Quote Link to comment Share on other sites More sharing options...
Recommended Posts
Join the conversation
You can post now and register later. If you have an account, sign in now to post with your account.