IForgeIron Blueprints
Copyright 2002 - 2008 IFORGEIRON, All rights reserved.
BP1037 Wing Nuts 02
by Uri Hofi
The wing nut.
.
The wing nut is forged out of round steel 9/16'' 3 3/8'' long. Incised with the hold of the magnet and the 3'16'' fuller. And round it the same like in wing nut Blueprint
BP1036 Wing nut 01
With a 1/4-5/16'' fuller we neck down to the anvil until we get a 1/4 '' neck.
Bend it on the anvil fork a bit more then 45 degrees.
Hold with a pickup tongs in the middle and heat both sides.
Put both wings parallel od the air hammer die and forge. Be sure and hold firm.
The finished wing nut form.
Punching the hole.
The finished wing nut on the punch.
The finished wing nuts.
Recommended Comments
There are no comments to display.
Join the conversation
You can post now and register later. If you have an account, sign in now to post with your account.