Blueprints
Blueprints for blacksmithing.
Subcategories
-
00 series
00 seriesNo articles here yet -
No articles here yet
-
No articles here yet
-
- 64 articles
2 articles in this category
-
Anvil Hold Down by Nobody Special Copyright 2002 - 2014 IForgeIron, All rights reserved. January 7, 2014 A quick fix to hold stock I found while punching a hole for a hammer. I was working on a hammer out of some two inch stock from an axle today, working by myself, and just couldn't manage to keep the stock in the right position. My anvil's missing the heel, so no hold down in the pritchel or hardy. And of course every time I'd try to hit the punch against the stock it would roll, eve
-
Teaser Paragraph:
Anvil Hold Down
A quick fix to hold stock I found while punching a hole for a hammer.
-
-
IForgeIron Blueprints Copyright 2002 - 2011 IFORGEIRON, All rights reserved BP0367 Forge Blower Duct by Gerald Franklin This re-cycled bathroom heater blower on my forge finally gave up the ghost and had to be replaced. I was in a hurry and didn’t want to get into a drawn out sheet metal exercise. The squirrel cage blower was being replaced by this 4 ½” muffin fan. It came from Surplus Center (www.surpluscenter.com) and cost about $15. It is rated to
-
Teaser Paragraph:
-
