IForgeIron Blueprints
Copyright 2002 - 2007 IFORGEIRON, All rights reserved.
BP1019 Riveting a cup on a candle holder stick
by Uri Hofi
Putting a cup on a candle holder stick is some times a problem I developed a simple system to rivet the cup and I want to demonstrate tonight.
The monkey tool and chisel tool.
The monkey tool hole is 5,5 mm The chisel hole is 4,5 mm The depth of the holes is 25 mm The tools are made of h13 or s1 steel.
The OD of the drilled hole in the chisel is 3/16 inches and in the monkey tool is 7/32 inches.
The stick is forged to 7/32-1/4'' OD and then pointed Before and after forging the point.
The cup from top and bottom The hole in the cup is 45 mm, or 3/16 OD.
Hold the stick in the vise Try the candle cup to see if it fits.
Heat the cup with a rose bud torch.
Put the cup on the point Set the cup to the point with the monkey tool Hammering light and fast with a small hammer, rotating the monkey tool until you feel the monkey tool is touching the corners of the square point then stop.
Dip the chisel in the lube Hammer again while rotating the chisel The square pipe that is welded to the chisel allows you to maintain a good grip while rotating You hammer until the chisel cuts the corners of the square point and rivets the cup.
The riveted cup.
The riveted stick with the cup The same system can be applied to other places and other dimensions too.
Recommended Comments
There are no comments to display.
Join the conversation
You can post now and register later. If you have an account, sign in now to post with your account.