here is a new tool to fit a hardie hole, one of my tool holders or just clamp it in a vice

inside it is about 50mm ( 2" aprox )

outside it is about 60mm ( 2 3/8" aprox )

shank is 20mm square but can be sleeved to fit

will have a few at wood green in a couple of weeks and later at TORM

Thats a nice tool ID. Could make multiple sizes as well. 

I have a set similar. They are made from seamless black pipe. they aren't as polished. I They go from 3/4" up to 6".

the major difference is that I forge (roll) the top edge of the pipe outwards instead of revelling like you do. This gives me a few more forging options and better prevents unwanted mark's on the work than rounded edges.

The other difference is I use a horizontal bar instead of vertical do I can clamp them in my post vice.

lol, variations on a theme.

those look good     ! if i may be so bold?what do you sell them for?

For dishing of course!  

sold today for 20 uk pounds, now have to make more

On 10/21/2018 at 5:29 PM, Daswulf said:

For dishing of course!  

money ? smart i like , smart Ar.. not so much  

Thanks ID. seems like a good deal for both parties?

yes it was good, I found a stack of these pieces in 3 sizes, weld in a lasercut part I have and some 20mm square and its ready for use, the radius on the top is how I found it

now made a larger and a smaller one and another medium one ready for an event here