This is my second attempt at a cobbler hammer that I made for a friend that does leather work. It weighs in at 27 oz he wanted 24 but I over shot a bit because I wanted to give him weight to dress it.

 

Nice work. 

Thanks a lot it was tons of fun to make. I used a chunk of the axle from the rear end off my bronco. I had to upset it quite a bit to get the face as large as I needed and it took quite a bit of beating to flatten out the peen. I was more methodical about my hammer strokes on this one and did very minimal grinding.

Is it just the way the picture was taken, or was the eye for the handle a little crooked? Other than that, magnificent job!

 

~Travis

Thank you, the eye is a little off but the wedge makes it look more so.