April 11, 201016 yr In this video, Jim Poor gives us and idea about how he makes tongs. This is a trailer for his dvd so lots is left out. What I really want to know is, in the portions starting at about 2:54 in the video, he is using a striker to shape the tongs over the bick in a very specific way. I want to know how one might accomplish the same thing w/o a striker. Video to follow:
April 11, 201016 yr I can think of two ways that i might do it. The first one would be to probably just use my cross pein and keep my hits as accurate as possible. Like he said just a little bit at a time, dont rush it. The second and more time consuming one i might consider if i was going to make a few of these tongs would be to make a spring fuller that would only have a top section. The top would be probably a 1/2 or 5/8 round bar that would extend past the face and use the horn as the bottom of the fuller. I dont know how well this would work but it is just an alternate idea.
April 11, 201016 yr Most straightforward method would be good hammer control. I have tried that method since it looks so good and clean. Generally I went to using long stock and gripping between my legs. In effect becoming my own striker. More recently though, I go to my treadle hammer for the help.
April 11, 201016 yr I think he best answer would be to look at the thread "one heat tongs" by Brian B. He has videos to show how to do it there and even a demo using clay. More than one way to skin this particular cat.
April 12, 201016 yr Strikers make things easier but I can think of several ways the same thing can be accomplished with just one blacksmith. Contact the blacksmith in the DVD and ask him.
April 13, 201016 yr My 2 cents I would make a spring fuller with the bottom the same shape as the horn and the top with a 1/2" to 3/4" round stock depending how much an impression you want.
Join the conversation
You can post now and register later. If you have an account, sign in now to post with your account.