keithh999 Posted January 27, 2008 Share Posted January 27, 2008 heres my first two roses from Alwins demo last weekend....not too bad i dont think....can see room for improvement which can only come from more practice Link to comment Share on other sites More sharing options...
newbiesmith Posted January 28, 2008 Share Posted January 28, 2008 Looks great Keith. I think that's as close as one can get for a first attempt. It's alot closer than what I could have gotten. Did you end up using that sweet little gasser that you were showing off at the meeting? What was that site that you said you got the design from again? I didn't write it down and have been kicking myself since. By the way thanks for the blower. I finally got it and the control unit installed on the forge. Now I'm just waiting for a a nice day to fire things up. -Dan Link to comment Share on other sites More sharing options...
yesteryearforge Posted January 28, 2008 Share Posted January 28, 2008 Nice job ( especially for your first try ) Mike Tanner Link to comment Share on other sites More sharing options...
keithh999 Posted January 29, 2008 Author Share Posted January 29, 2008 i got the burner design from melting metal in a home foundry, backyard metalcasting, metal casting my orifice is a #60 drill hole rather than his recommended #57-58. the single rose took about 30 minutes to make and the one with the leaf took about 45 minutes will hammer out a few more this weekend in and amongst a few other goodies i would like to try. Link to comment Share on other sites More sharing options...
fat pete Posted January 29, 2008 Share Posted January 29, 2008 looks like a good blue print Link to comment Share on other sites More sharing options...
Recommended Posts