Brasilikilt Posted July 1, 2009 Posted July 1, 2009 Hey all I thought I would pass this one alonground saw anvil Not the type of anvil I'm looking for, but figured it may be perfect for somebody else. Quote
ThomasPowers Posted July 1, 2009 Posted July 1, 2009 According to my calculations that should weight 350# if 20" dia and 4" thick! Quote
Avadon Posted July 2, 2009 Posted July 2, 2009 Seems like that would make a decent anvil for some work but when your hammering it doesn't have a lot of mass under neath any one section. Only 4". The rest of the mass might help absorb blows. If it was square then you could use it on it's side and then you would get the full 20" of mass under each blow. What were these anvils originally used for? Correcting saw blades? Quote
bamboolongbow Posted July 3, 2009 Posted July 3, 2009 (edited) Maybe this anvil was used adjust the large Saw Mill blades. I like the single handle. Edited July 3, 2009 by bamboolongbow Spelling Quote
Recommended Posts
Join the conversation
You can post now and register later. If you have an account, sign in now to post with your account.