Made a new stand for the anvil!

Ayup, that's a fine anvil stand. If it's a little tippy, remove the anvil, flip it over and nail a piece of ply wood to the bottom. It'll steady it up and you won't trip over the edges of a wide base.

Well done.

Frosty The Lucky.

Thank you frosty the one I had before was kinda thrown together to just get the job done,but I was making a cupping tool and using a sledge to do so needless to say didn't hold up very long.. and it's not to bad it sits alright I buried it to try to prevent wobbles but should it happen I'll do just that

Stands usually have less flex to them if you orient the boards vertically; they can then be glued or bolted together too.

Thank you for the tip I'll do that with the next one if I need it