May 5, 20206 yr Not sure but I figure Finish and Polish for Forks goes here as well. Had a piece of twisted 15n20/1075 bar laying around so I made a traditional two-tine fork by hot cutting one end and drawing out the other for the handle. Drawing out the tines was a very delicate procedure due to the inclination of the low layer laminate to split. Had to forge weld one tip to get it back to one piece. Did a ferric chloride etch followed by a 5 hour soak in Nescafe (decaf of course).
May 6, 20206 yr Author Lasagna could work, spaghetti not so much.... Certainly the crafting of this gave me some good practice at draw filing!
Join the conversation
You can post now and register later. If you have an account, sign in now to post with your account.