Baxter Posted January 28, 2018 Share Posted January 28, 2018 got a couple pics last night. Wondering what you think how does this look? What adjustments would you make? Quote Link to comment Share on other sites More sharing options...
Mikey98118 Posted January 28, 2018 Share Posted January 28, 2018 Overwhelmingly rich. Quote Link to comment Share on other sites More sharing options...
Baxter Posted January 28, 2018 Author Share Posted January 28, 2018 That's what I was needing to know. I'm using Frostys design. I'll start moving my tips further away from the mixing tube. What should I be looking for that its burning correct? Quote Link to comment Share on other sites More sharing options...
Mikey98118 Posted January 29, 2018 Share Posted January 29, 2018 Reduce that flame as much as you can, by reducing input gas pressure. Your goal should be an outcome you can work with; not perfection. Quote Link to comment Share on other sites More sharing options...
Baxter Posted January 29, 2018 Author Share Posted January 29, 2018 Thanks Mikey, I dropped the gas pressure but then it starts sputtering? any suggestions are always welcome. Quote Link to comment Share on other sites More sharing options...
Mikey98118 Posted January 29, 2018 Share Posted January 29, 2018 You may need to replace your burners with smaller ones. Every burner has a minimum stable fuel pressure; the larger the burners the greater the pressure. It's not like your present burners will be wasted; you will simply use them in another project. Quote Link to comment Share on other sites More sharing options...
Howling dog forge Posted January 31, 2018 Share Posted January 31, 2018 I am guessing you have an .035 tip for your gas jet? what would changing to .030 do to this situation? what is the interior volume? Quote Link to comment Share on other sites More sharing options...
Baxter Posted February 5, 2018 Author Share Posted February 5, 2018 howling dog forge, interior is about 1000. I did change to .30 but its been a wild week. I'll get some pics in the next couple days. Quote Link to comment Share on other sites More sharing options...
Jacob Palmer Posted February 5, 2018 Share Posted February 5, 2018 2 hours ago, Baxter said: I just recently built a Frosty T burner. I bought 0.035 and 0.025 mig tips. The 0.025 worked best for me though I used a strange setup. Experiment with grinding the tip down a little. You could also try regulating the amount of oxygen that gets to the gas. Quote Link to comment Share on other sites More sharing options...
Recommended Posts
Join the conversation
You can post now and register later. If you have an account, sign in now to post with your account.