canada goose Posted April 1, 2017 Share Posted April 1, 2017 (edited) Does anyone have any nifty tooling ideas they would like to share ? Double posting 5 hrs apart will not get replies faster Edited April 1, 2017 by Moderator86 Double posting by member Quote Link to comment Share on other sites More sharing options...
Judson Yaggy Posted April 2, 2017 Share Posted April 2, 2017 Here is a good place to start. http://www.alaforge.org/files/Tire_Hammer_Tools.pdf Quote Link to comment Share on other sites More sharing options...
canada goose Posted April 3, 2017 Author Share Posted April 3, 2017 Judson, you're right thats a great place to start. I was hoping to see some further developments and refinements perhaps . And some brilliant new ideas ! Quote Link to comment Share on other sites More sharing options...
Al Stephens Posted April 4, 2017 Share Posted April 4, 2017 I draw a lot of pre cut lengths to a specific length, this has helped, and saved a lot of time over the years. Just a piece of angle iron, marked at 1 inch increments. Use vise grips to set a stop. Quote Link to comment Share on other sites More sharing options...
Stitch Posted September 1, 2017 Share Posted September 1, 2017 Now that is super handy!! Great job, thanks for sharing! Quote Link to comment Share on other sites More sharing options...
Recommended Posts
Join the conversation
You can post now and register later. If you have an account, sign in now to post with your account.