droesse Posted March 17, 2017 Share Posted March 17, 2017 Just wanted to share my forge build pics with everyone. I gathered most of the relevant knowledge from people here sharing their experience so if anyone has any questions (or advice) please feel free to comment. Mikey I went with a smaller orifice in the torch mig tip like you suggested and it works much better. The last 2 pics show one of the burners at 3psi on the idle circuit and then at 10psi on the main circuit. The burner flames become almost invisible over about 5psi. I am very pleased with the outcome and just want to thank everyone here for their contributions to this site. Quote Link to comment Share on other sites More sharing options...
Frosty Posted March 17, 2017 Share Posted March 17, 2017 It sure looks to be running well. Nice build on all counts. How long have you run it continuously? Frosty The Lucky. Quote Link to comment Share on other sites More sharing options...
droesse Posted March 17, 2017 Author Share Posted March 17, 2017 Thank you! I just finished the gas manifold today and only ran the 2 burner setup for about 15min. But I did run it with only one torch for about 3 or 4 hours the other day. I am using vermiculite board coated in ITC100 for the doors. This is not going to last very long so I am going to try bricks instead I think. Quote Link to comment Share on other sites More sharing options...
New axe maker Posted March 19, 2017 Share Posted March 19, 2017 Looks great. Quote Link to comment Share on other sites More sharing options...
Recommended Posts
Join the conversation
You can post now and register later. If you have an account, sign in now to post with your account.