Search the Community
Showing results for tags 'installing'.
Found 2 results
-
I am making a gas forge. I am using a water heater tank. The dimensions (outer) of the tank are 24 inches long by 20 in diameter. I have enough cerachem to line it to a three inch thickness. I am going to make a forced air ribbon burner for it. I am going to build the blower so that it will provide a static pressure of at least 25 inH20. That should be plenty from the stoichiometric calcs. I have a refractory coating to coat the cerachem and a couple of firebricks (good to 3000 F) for the deck. My main question at this point is what do I need to do to install the cerachem? Will it stay in p
-
So I am installing a short railing approximately five feet long onto a set of church altar steps (to be used by the elderly priests who have trouble walking up and down them) the dilemma I am having is about deciding which anchors to use as the top face of the floor is marble and supposedly the underside is concrete but no one is really sure and I have a limited time to install the railings. If anyone has any ideas about what anchor to use or could point me in the right direction it would be much appreciated. Thanks. Robert Burns
