Hey guys! Tyler here, this is going to be my first propane forge build and I’ve done research and any input would be greatly appreciated! Here’s what I have in mind:
1) After removing the valve from the tank as well as the base ring and top ring around the valve.
2) I plan on cutting both ends off of the propane tank(the same amount off of each end)
3) Each end removed will be hinged, but will aslo have a smaller 4”x6” hole identical in each door as well
4) I plan on lining doors, tank with a double layer of 1”Inswool, will then coat with 1/4” of satanite, and a few coats of ITC 100
5) fire brick in bottom of forge, I have 2 Geode style burners ( given to me as gifts) I think they were bought off amazon, I was thinking they should enter the forge at 45 degree angle
6) was also given a 100lb propane tank to use for the forge
Is there anything I should change? Any suggestions would be greatly appreciated I have no experience in this so these are my plans after doing my own research thanks in advance!