Michael Posted August 31, 2015 Share Posted August 31, 2015 I bolted this vise stand together a few years back. Big cast iron sheave, a cafe table base and some plate for a table.Then the table filled up and stuff started dropping off the edges. Lived with it for a long while.Recovering from a bad wrist strain, forgot I wasn't twenty years old, and couldn't forge for a bit.Decided to do something about that table. 36 inches of angle iron, a couple of notches for bending, fired up the propane forge for some bends.A few more bolts and the table has a lip! Should have used inch and a quarter or inch and a half angle instead of one inch. Didn't take the 1/4 plate table into account. Quote Link to comment Share on other sites More sharing options...
Recommended Posts
Join the conversation
You can post now and register later. If you have an account, sign in now to post with your account.