monty Posted June 15, 2011 Share Posted June 15, 2011 these are my first attempts at a ring and a test tube flower holder (as far a i know my design of flower holder) Quote Link to comment Share on other sites More sharing options...
Bentiron1946 Posted June 15, 2011 Share Posted June 15, 2011 Yeah, you got a ring started there for sure, hard to tell from the photo if you got any detail on the leaf or not but a good start for sure. The bud holder looks a little more finished and thought out, also a good job on that one. B) Quote Link to comment Share on other sites More sharing options...
Alec.S Posted June 15, 2011 Share Posted June 15, 2011 Very nice monty! That is way better than my first attempt! With the ring, if you lay the leaf bit face side down over the ledge of the table on your anvil and with a cross peen bend the leaf, you can make the leaf round ,so that the ring is round. I like the test tube holder! It is very nice! alec Quote Link to comment Share on other sites More sharing options...
monty Posted June 15, 2011 Author Share Posted June 15, 2011 the leaf is curved, and i was going for simple, it has only a slightly raised vein in the centre, no other markings, it was good fun i think i may be making more! thanks for the comments! Quote Link to comment Share on other sites More sharing options...
Alec.S Posted June 15, 2011 Share Posted June 15, 2011 oh right, yeah sorry... the first time i looked at it it looked squished and flatter... Quote Link to comment Share on other sites More sharing options...
monty Posted June 16, 2011 Author Share Posted June 16, 2011 actually there is no vein at all, but it is nice simple! Quote Link to comment Share on other sites More sharing options...
monty Posted June 26, 2011 Author Share Posted June 26, 2011 flower holder in use Quote Link to comment Share on other sites More sharing options...
Recommended Posts
Join the conversation
You can post now and register later. If you have an account, sign in now to post with your account.