Jump to content
I Forge Iron

TMusick-Slater

Members
 View Profile  See their activity

  • Posts

    3

  • Joined

  • Last visited

Profile Information

  • Gender
    Male
  • Location
    Moyie Springs, Idaho, USA
  • Interests
    Blades, tools, recycled/upcycled materials.

Recent Profile Visitors

The recent visitors block is disabled and is not being shown to other users.

  1. TMusick-Slater
    No forging, just learning to weld and had some free junk from work. The shank is improvised square tubing from angle iron. Couldn't fit as I went as the welder is far from the anvil. I did have some measurements but the hardy hole has some wear so the narrowest point is narrower than I was able to measure. Probably just use an angle grinder. It's close and if it breaks, I'm out but a little time and up quite a bit of experience. Order of operations is certainly an acquired skill.
  2. TMusick-Slater
    Not quite fit to the anvil yet, but this is my super fresh hot cut. Gonna try to hot fit it today.
  3. TMusick-Slater
    The bottom two look like engraving tools.
×
×
  • Create New...