Hello
I recently acquired a 25# little giant and have a few questions. I've been doing a lot of reading but this is my first power hammer so I sure have a lot to learn.
Here is the hammer
From everything I have read it should be dripping in Oil, I am assuming that the below should be filled with oil? When I put oil in the front one I can tell its goes down but the lvl in this one doesn't seem to change.
The hammer is set up with grease zerk fittings but one broke off and the threads are stripped can I just oil that location? I am thinking of just jbwelding a nipple in there as well. Also on the topic of grease, will any decent grease work ok?
Lastly when I run the hammer it just keeps striking as you can see below. I start it and then immediately take my foot of the petal but it just keeps going. I made sure it is nice and oiled back there but that doesn't seem to change much. Thanks for any help or advise anyone can give I appreciate it. I am super excited about this hammer now I just need to learn all I can about it.