Hi,
I need your help. I am preparing my gas (propane, devil forge) forge in my garage (width : 3m, height: 2m45, length : 5m40 in metric system).
I put my forge between plasterboards (wall of 5cm width with ceramic wool). The left and right sides are 1m (width) x 2m (height) and the back wall is 0.65m x 2m.
The forge is located at 1m50 of height. So the problem is there are no ventilation but my "forge walls" are located in a corner of my garage.
The walls of my garage in this corner are the two faces (left side width: 3m, backside width : 5m40) linked to exterior.
The outside doors are not easy to open. So I can do it until I buy all elements of my air system but it is not ok on the long term.
I am worried about monoxide and I would like to design it properly to avoid intoxication and death. I read that air extractor and ventilation are mandatory but I also read that it is recommended to put an aspiration close to the forge. I also have other tools like backstand, grinder and saws.
Can you give me advises? How to size air system, where to put air elements?
Maybe some online international shop links?
Thanks!