Adodero
-
Posts
28 -
Joined
-
Last visited
Content Type
Profiles
Forums
Articles
Gallery
Downloads
Events
Posts posted by Adodero
-
-
I've been trying to get an understanding of the same thing. I read another post somewhere and a user of the same forge changed out the valve tips to achieve lower temps. I reached out to Chile to ask if this is a supported configuration and works, but haven't heard back yet. I read someone else talk about choking it down to run cooler, but never any reply on how to accomplish that.
I know you can turn the burners off individually. I wondered if you turned on one of the rear burners only and used the front of the forge for lower temp operations?
I have one ordered. If I go through with it, then I will experiment and see, but it could be 10+ weeks.
-
I've looked for concrete answers on this question, but mostly ran into questions on coal forges or speculative solutions, so I'm curious if someone has any input or has tried this.
I have a fairly large 2 car garage (2 cars + room on either side for a shop, could probably fit 3 in) with several windows and a large door. I'd like to run my propane 2 burner NC forge in the garage and vent the heat/fumes outside. I understand the CO issues and have CO monitors at floor level, head level, and a gauge next to the forge, along with fans in each window and a fan blowing air into the garage from the outside via the garage door. My main concern is preventing heat and fumes from collecting on the ceiling, which is about 11ft high.
My thought was to use a sheet metal hood with a lot of space on either side, mounted as high above the forge as possible (realistically the top of the hood will be about 4-5ft above the forge), to capture the fumes and an inline duct fan to blow the fumes out via 10-12in ducts. I figured mounting it as high as I can would allow the air to cool a bit, but I'm not opposed to lowering it. I took some inspiration from hoods used by glass blowers to vent fumes.
I've tried to measure the temp of the fumes/air above the forge while it's running, but it's difficult outside to get an accurate measure since it moves around.
Has anyone successfully done this or tried it?
Chile Forge Too Hot?
in Gas Forges
Posted
I reached out to Chile about this and they told me that they don't recommend using their forges to HT, apparently lower temps will damage the burners somehow?
In any case, that answered my question about them. I still plan on going through with it, because I like the burner design and specs on it compared to my Knifemaker, but it is a bit disappointing to hear considering I read otherwise on a few other posts.
Mine won't arrive until December, so we'll see how it compares then.