Caballo bueno

but I want it for a blast forge

It's blast forge and if sometimes I use coal and other times coke

Do you have the air tube at a depth of 10 cm?

How much would it be in centimeters? It's for a blast forge

How do I determine the depth of a forge for coke and coal? I work with these two coals because the availability here sometimes there is coke other coal

How are the bearings fitted in their bore?

Lol

I don't know how to make a bearing for the shaft where it goes through the casing

Thank you

I will make the casings with two butane bottle bottoms, what I don't know is how many blades to put or the air outlet tube

Does anyone have experience making crank blowers with bicycle sprockets?

if I say it because of the slag that sticks and you take half a forge if the mortar is not good...

but the clay can get very hard and the slag when sticking will not take a good piece?

Is silica sand essential? What mix would you use your Charles?

With which biker could I wrap the nozzle so that it doesn't burn?

Okay. What if I mix it with lime? How do I protect the tube from burning without using a water tank behind it?

I understand... I mean, do I use ashes and the charcoal powder from the mixture? Does the clay that I mix with the sand have to be refractory? What about the cat litter?

Hello! I continue with my research on lateral blast forges and my question is if there is any clay or sand that repels the slag and does not stick to it. Greetings

yes home

Which sands or clays repel slag? The silica sand sticks to it.

How do I determine the width of the side draft firebox and the depth?

Hello?

what is a jabod?

They are not 4, they are 40 mm of the diameter of the tube through which the air comes out to the stove

I can put a pipe in the 40 mm shaft, but I don't know what measurements to give the crater to heat pieces like 4 mm thick bars, etc.