Jump to content
I Forge Iron

JordanC

Members
  • Posts

    3
  • Joined

  • Last visited

Profile Information

  • Gender
    Male
  • Location
    Warwic, UK
  • Interests
    Machining, engineering,

Recent Profile Visitors

The recent visitors block is disabled and is not being shown to other users.

  1. I’ve used a wire brush to remove the surface rust, there are no traces of any markings anywhere!
  2. Thanks for the reply! Hopefully somebody may be able to I.D it!
  3. Hello! I have scoured the forums as a guest looking for clues on the manufacturer of this anvil. It’s in very bad shape, I purchased it for £90.00. I may have overpaid? Just wondering if anybody on here could identify it? The remaining top plate, when a ball bearing is dropped from 12 inches it rebounds to 9 inches. On the rest of the face is rebounds to 6 inches. The horn is horrendously damaged too. It looks like it’s had a terrible life. I’m a machinist by trade in the Midlands, UK. I had access to all the equipment, material, heat treatment etc to attempt a repair. I’m thinking remake the top plate out of something decent like 2767, heat treat it and then have it welded on. I can wire cut a new hardy hole in the new plate. I’m getting ahead of myself though. i’ve joined the forums to read and research the best way to go about a repair. Before I start researching I am very curious as to who the manufacturer is? if anybody could shed some light, I would appreciate your help very much!
×
×
  • Create New...