michigan anvil
-
Posts
3 -
Joined
-
Last visited
Content Type
Profiles
Forums
Articles
Gallery
Downloads
Events
Everything posted by michigan anvil
-
pressure gauge does not show any pressure when i run the press
michigan anvil replied to michigan anvil's topic in Presses
Andrew, I reversed the motor and it reversed everything the fluid discharged back to the tank from the pump in port and the discharge hose sucked up fluid. Glen, I have set the system up according to the Batson formulas, but, I will double check everything tomorrow. Thank You both for your input -
Hello, I just finished and fired up a press built from the Batson Plans. The cylinder is moving very slow, the pressure gauge does not move. What am I doing wrong? The gauge is inline between outlet of pump and inlet to control assy. It does move up and down but, slow. I have used presses before and they have not done all of this.