First: Thank you for your patience during all of these exchanges! Next: Which procedure do you recommend? I've used helve
hammers, steam converted to air, Little Giants and a 10lb sledge. What is the best material to get the best results from the
Bradley? I will be making Damascus and knives in general, flattening a lot of 1/2 inchby2"down to sizeable stock and so on.
I would prefer the leather. Purchased from you, is this something you would be willing to undertake? There is money involved, is
it sufficient for the job done? I don't have the skill (or the leather) to undertake this, so it would be you.
Is it possible to get canvas strap from you for the pulley assemblies? Lastly, the installation of the belt on the machine. I am
assuming that on one end of the belt there is a loop that the spool will be fitted through so that the belt can be fed through the
ram over the other spool and back again finally the end threaded into the bracket and bolted down. That is how it was when I
removed the broken belt. Was it correct?
Thanks again
Dave