johndeere

My brother inlaw found me a compression coil spring that replaces the missing spring great. So I got the vise cleaned up and painted. Put it back together this morning. Here is a pic. Was going to add more. But for some reason I keep geting an error everytime I try to add the others.

I like your idea. that way I don't need a new bracket. And it will be out of the way. Ty i think I'll give it a try.

ty stephen. i will listen and look at any ideas. i will see what i end up doing. so far the tusk tennon is right at the top of the list.

On the inside end of the tenon it has a head like a rivit. And goes through the post as a small rectangle then is twisted and made in to 2 out sweeping mounting brackets. That link wont work for me.

The problem im having is I dont want to change the mount its a tenon mount. I can make a clip but I"m not sure how I can make a spring.Ii only have about 5/8 of an inch between the pivot plates to fit a spring in. So I am kinda at a loss right now. If I had an idea what the spring was like on it and how it fastened to the post before I might be able to come up with something but no luck so far.

No not any stamps or marks that I can find. But I am thinking it is German. I got it with a blowtorch and some wood augers both of them are German. And from what I have read and how far up the sides the side braces run it sounds like there is a good chance it is German. The jaws are 3.5 inches.

i gut this vise a week ago and now have it totaly apart cleaning it. but it dont have a spring. any good ideas on how to make one?

the last vise look almost the same as mine. except mine has a tenon mount.