Jump to content
I Forge Iron

square hold down


Nobody Special

A quick fix to hold stock I found while punching a hole for a hammer.


Recommended Comments

How does that work? Is there something off to the right side affixing it to the anvil or does it just cap the part you are working on?

Link to comment

I put a little bit of a taper where the peen will be, and it's lightly wedged into the square tubing to keep it from rolling while I'm punching.

 

No hardy on my anvil since the heel's broken off, and I got tired of it moving on me. The tubing's just sitting there, no attachments, but between it and holding the punch in one hand, I had a lot more control. With smaller stock I could ding the tubing in a little for a smaller diameter. Theres a forum for it under shop tricks.

Link to comment

Join the conversation

You can post now and register later. If you have an account, sign in now to post with your account.

Add a comment...

×   Pasted as rich text.   Paste as plain text instead

  Only 75 emoji are allowed.

×   Your link has been automatically embedded.   Display as a link instead

×   Your previous content has been restored.   Clear editor

×   You cannot paste images directly. Upload or insert images from URL.

×
×
  • Create New...