DevanMcDavitt
-
Posts
2 -
Joined
-
Last visited
Content Type
Profiles
Forums
Articles
Gallery
Downloads
Events
Posts posted by DevanMcDavitt
-
-
I have been spending my time at my forge trying to forge out some field point arrow heads, but I cannot seem to find a reliable way to attach these arrow heads to the homemade arrow shafts. My idea was to forge it out thin and create a sort of skirt that I could wrap around the arrow shaft , but I don't know how to attach it from there. Has anybody here ever forged some field point arrows and have some advice for me? Any ideas are appreciated.
Atlas forge does not reach forge welding heat
in Gas Forges
Posted
I purchased an atlas prototype v4 forge a few months back and no matter what I do, I cannot seem to get this thing to heat up to a welding heat. If I block it up too much with fire brick, the burner sputters, if I leave it open enough for a consistent flame, I reach an orange heat at best. This is the second burner they sent me after the first one would not consistently keep a flame and would constantly fail sending a flame out of the pressure reader thing. Does Atlas make bad forges and I was dumb enough to buy one? or am I likely doing something wrong? I run the burner off a typical 20lb propane tank.