ka-tet
-
Posts
5 -
Joined
-
Last visited
Content Type
Profiles
Forums
Articles
Gallery
Downloads
Events
Posts posted by ka-tet
-
-
The chokes are open completely, so I'm not sure how to get more oxygen in.
-
So basically it is just to xxxx big.
What if I put in a small pass thru at floor level, then filled in the back 4 to 5 inches with mizzou? Effectively reducing the inside capacity by leaving a pass thru.
I measured and is about 600 cubic inches total. Inside is 20 inches long. 7 inches high. And 4 to 5 inches high (not uniform).
-
Thank you for taking the time to comment hg. I really appreciate it.
I haven't measured it directly yey but I'd hazard to say it is about 700 as you guessed.
I've been thinking and looking for a good solution to plug the back and reduce the size when not needed.
My goal with it is to (eventually) try my hand at some longer blades and swords. So I built it knowing that was a long term goal.
I don't want to just stuff the back with kaowool cause fibers /bad but I'd love any suggestions for a temporary plug. Was going to put a shelf on the back too so I could at least stack a brick there to close it off but haven't had time yet.
-
24 inch long air compressor tank
2 - 3/4 t-rex burners
2 inch kaowool covered/sealed with mizzou castable
slathered on itc-100
high temp temp probeI can get to about 2200F (according to probe) but it definitely takes a while, and about 16 psi to achieve. I'm wondering if my burners aren't quite tuned properly. The dragon's breath is mostly blue, which I assume means it needs more air, but i'm running it with the chokes almost wide open.
Ideas? Comments? helpful critiques? harsh critique? I'll take them all.
New guys forge build pics and a ? about ITC-100
in Gas Forges
Posted
I used the design from Hybrid Burners for my bypass. Those Rob's plumbing (and forge in general) is WAY more elegant that what I ended up with. Nice work!
http://www.hybridburners.com/pics/idle-full.jpg