Foamhead

Ok got my forge set up with brick 'Doors' which helped to get my first successful test burn and heated a little rebar to see where my temp was i still get an occasional "chimney fire that blows right out and improves and temp comes up in forge but still very unsettling and with the flame "spill out the end i did lose some beard leaning in to puff out the flame should i add a "roof brick at each end to clean up the convection around the venturi? I know i am still not in the category where these posts should be but i will work on refining my 'behavior' in the future, meanwhile thanks for the assist from each of you it has been helpful and supportive IMG_0719.MOV

Thanks Mikey98118 the replacement regulator that i purchased has a braided cover on the hose and is six foot instead of four i am having some trouble getting the regulator to thread onto the tank properly so the on /off valve on the tank will function it worked fine the first time after shut off i havent been able to get the valve to open again i have several grills and smokers and have never had this problem and if i ever do get it back on what is a good pressure for warm up and forging

I recieved an inexpensive Hells Forge single burner oval forge with 1" spun ceramic with surface treatment insulation and a pretty questionable regulator with no gauge, and no instructions whatsoever which i after one try at lighting it replaced it with a Kibuw 30psi regulator with gauge so my first question is where do i start as far as the air adjustment collar at top and propane PSI? i dont know the size of the tip orifice sombody start me out so my son can pound some hot metal