Hi All, I recently got my first propane forge, it's 100k BTU model, but I cant seem to get it going correctly. I have it attached to a 20 pound tank if this is relevant pressure wise? I was told I should be able to at least get it going, its a fresh..brand new tank. I started it about 4 times and have tried the following Keeping at a lower pressure and it goes out... At higher pressure it starting cutting in/out and sputtering. However... 1 and 2) At the Burner itself fire appears around there and the rubber area and I am forge to turn it off as that can't be normal having fire at the tip of the burner. So take #3---4 Turn it on again and have it about 18/20 setting and it rolling...then it starts "sputtering" and cutting in and out. I am then again forced to cut the gas and retry. This was my best attempt..Any advice. *) It should not have flame at the burner itself..correct?
