1 inch mongo burner

Cute l'il forge :) Is it the angle? Mabe distortion in photo? The gas tube seems to appear to be off center. You'll get a better more stable flame if it is dead center in tube. If its my eyes, my apologies :)

The tube is off center in the picture. I juat had it stuck together to see if liked the whole set up. Its runs great though. I have sence learned thar i am using too small of a mig tip for the burner to run at full capacity. I am going to put a larger mig tip in it so i can got a neutral burn when the choke is fully open. I am also working on a 3/4" mongo that i am going to modify slightly from this design. Thanks for the input and advice.