Dune32
-
Posts
4 -
Joined
-
Last visited
Content Type
Profiles
Forums
Articles
Gallery
Downloads
Events
Posts posted by Dune32
-
-
Thanks! Definitely seems like some pretty heavy work has been done on this anvil, I am excited to be putting it back to work. Wasn't sure if anyone with Postman's book would have any thoughts, but it's cool to hear confirmation that it's likely pre 1830s.
-Dune
-
-
Hi All,
Looking for your expertise on identifying this old anvil. My uncle found it for me, and so I don't have any idea where it came from. It weighs in at around 210 lbs, and due to the lack of a Pritchell, I am assuming that it is probably predates the 1830s, but could obviously be wrong. The Hardie hole measures approximately 1 1/4 inches. Pic with my hand on it gives you an idea of it's general size, but I will give you specific measurements if you prefer.
Thanks!
Dune
Attachments require that you download and install viewers. Files have been deleted. If you wish to attach files to your post, please use standard image formats.
Antique Anvil Identification
in Anvils, Swage Blocks, and Mandrels
Posted
Well that's cool!
I did do a small amount of grinding, where the hardened face was mushrooming out over the sides, and I could see some hairline cracks forming. I then radiused the edge so that it wasn't sharp and brittle. I used a sanding wheel on my angle grinder, and made sure nothing got even remotely warm. That's definitely all I am going to do.
It rings pretty well, except for a dead spot above the crack on the heel, but I think that's an area I can avoid pretty easily. As far as rebound, I haven't tested it with a ball bearing, but it feels pretty good with very light taps from a very small ball peen hammer (less than 8 oz). I think it will do nicely for me.
Thanks!
Dune