Matt NZ
-
Posts
2 -
Joined
-
Last visited
Content Type
Profiles
Forums
Articles
Gallery
Downloads
Events
Posts posted by Matt NZ
-
-
So here is my attempt at a NARB.
133 holes at 4mm. We used mails with the heads cut off to form the burner holes. The refractory was probably a bit green when we pulled them out as some nails chipped the top surfaces as they were removed but it still works fine.
This is it running at 5PSI
This is running inside the forge at 5PSI. The refractory was still curing so we didn't run it for long
Naturally Aspirated Ribbon Burner. Photo heavy.
in Ribbon Burners
Posted
Thanks. You guys did all the hard work figuring out how to get this far
How would recommend tuning it? Just trimming down the mig tip to get more air in? Its a home made T burner from 1" pipe and a 3/4 pipe as we couldnt get a reducing Tee.
I fired it up again tonight and this thing is hot! The whole forge internals are glowing at 4-5psi after 10minutes. Happily sat there for over an hour.
If I turn it up above 15PSI it hums like what Dan's did