Swadly

Ok I will take picture of complete burner Wednesday when I get back to shop!

Thanks Swadly

I ordered it from the place you referenced in a earlier thread id at flare is opening is 1 1/4" id at start is 1 1/8". OD of burner tube is 1" burner tube id 3/4"

Ok first flame Pic! Thoughts and suggestions. 3/4 burner 8" tube 1 1/4 nozzle 10Lb force!

Thanks Swadly

Very informative place with many ways to do things! Thats what has me on here everyday!

Thanks for your info sharing!

Swadly

I read Mikes book and thats what it said. Was just interested if there was any change in strategy ! Thanks for the info.

Swadly

Mike and Frosty fixing to drill holes in multi burner forge. Is the rule of thumb still no closer than the diameter and end no closer than the radius?

Thanks Swadly

Got the wrong silica!!! already have return label! 

Thanks Frosty

Any additional advice? I used my wife stick blender, shook it and still not mixing well!

Thanks Gent's

How do you get the rigidizer powder to mix in water?

Thanks Gent's

Mike final coating of the forge quick question about Zircopax. Do I need to add a binder to the mix? It says its bound by Sinter on DigitalFire.com but its not listed in the Zircopax formula.

Thanks Swadly 

I value your opinion Mike! Do you have any comments or suggestions?

This is a rough drawing of the burner. I have been reading a lot on the forums and got Mikes book! The reducer has been ground and sanded to a small funnel to increase the Venturi effect. The rest of the burner is basically Mikes 3/4" burner! 

Any thoughts or suggestions would be greatly appreciated.

Great place to learn! Thank you Swadly