justin chenault
-
Posts
7 -
Joined
-
Last visited
Content Type
Profiles
Forums
Articles
Gallery
Downloads
Events
Posts posted by justin chenault
-
-
Thanks for the info Jim I was worried that the 2" would be too small.
Well its back to the drawing board then.
So what size drive pulley would you reccomend for this size hammer?
The ram weighs roughly 75lbs and has a crank pulley 12" diameter.
-
The machine has a 5" wide flat belt pulley and is set up to run off a line shaft with a slack belt and tensioner so it is intended to have some slippage.
Are you saying it would have to much slippage?
I was planning on setting the motor up overhead in the rafters and running the belt down to the hammer I was hoping to avoid the jack shaft setup if possible but if not I guess I will use one.
-
so I just scored a 5 horsepower 1725 rpm motor for $300 so I'm hoping I can run a 2 inch pulley on the shaft to the 12 inch pulley on the hammer and be okay that should put me around 280ish rpm at the hammer. for you hammer guys does that sound like it'll work out
-
Sorry about not responding sooner
Macbruce- I am in central Ohio
jeremy k & tommy traylor - thanks for the info i now have something to base my search on
now I just have to get the foundation poured for it and get it powered up.
Everything seems to move freely the rubbers are in decent shapeI just need to get the motor hooked up and get a flat belt drive pulley for it and we are in buisness.
anyone know where a flat belt pulley for an electric motor can be bought from
-
I just picked up a helve hammer this weekend and I am looking for a ID on it.
I have been looking everywhere I can online and I cant find anything on it as there are no MFG marks anywhere on it.
Uploaded with ImageShack.usAny help would be great as I would like to come up with some kind of history on this hammer as I am trying to get it going.
Thanks
justin
new to me hammer looking for an ID
in Power Hammers, Treadle Hammers, Olivers
Posted
Yes I did