Jump to content
I Forge Iron

Recommended Posts

I found this in one of our barns, though its use and what it could be elude me, my guess is some sort of clamp or vise, but it only seems to be half of it. The jaw slides back and forth, but not up or down the shaft, and the screw adjusts the angle of the jaw. Anybody seen one of these before?

20200726_115300.jpg

Link to post
Share on other sites

Bottle capper? Maybe if the tooth on the jaw had a divot in it to cradle the cap as its pushed on, instead its flat. 

I haven't found much more than a hand saw when it comes to carpentry tools, but it may be a hold down. If it helps, this was found in the plumbing area of the barn, not to say that carpentry tools arent there (the grinding stone was so buried that it was a complete surprise when we found it) or that this is for plumbing, but most things were set in an area that had things used for similar jobs.

Size reference, standing on its leg, it comes to mid thigh on me, so ~2.5 feet tall without the extra from the screw and 2 foot long jaw. ~1+ inch solid round leg

Link to post
Share on other sites

What does the base look like?  I've seen something like that that was used for breaking the bead on a tire for repairs done out on the farm.  It had a fixture to go through the center of the tire though.

Link to post
Share on other sites

The base is the same as the rest of the leg.  I took another picture of it in a different configuration in case it helps. There was also a partial stamp on the arm. Looks like a B, possibly with a diamond around it

20200729_163527.jpg

20200729_163551.jpg

Link to post
Share on other sites

That looks really similiar to an old clamp set up I used to have belonged to my grandfather... mine had a round post like that- but was threaded on the bottom of the post for a locking nut, and the sliding adjustable bar at the top was a cast piece.

It was used in a garage as a valve spring compressor for cylinder heads. I know that from my father who used it to do that job before I was born. It would slide into a hole in the work bench, get adjusted for height and tighten the lock nut. Move over the valve stem and compress the spring to remove retainers.

Dont remember how I wound up with it after my dad, but without the bench and spring adapters... I never used it and think it wound up scrapped.

Just another possibility.

Link to post
Share on other sites

pretty cool though. will keep it in the back of my mind. for tires i use my farm jack and the door to my shop. set the jack on the tire, length of 4x4 up to the door jamb and all set.

Link to post
Share on other sites

Join the conversation

You can post now and register later. If you have an account, sign in now to post with your account.

Guest
Reply to this topic...

×   Pasted as rich text.   Paste as plain text instead

  Only 75 emoji are allowed.

×   Your link has been automatically embedded.   Display as a link instead

×   Your previous content has been restored.   Clear editor

×   You cannot paste images directly. Upload or insert images from URL.

×
×
  • Create New...