Jump to content
I Forge Iron

Recommended Posts

I am in need of an Anvil. I'm not looking to go and spend $400-$500 on an Anvil so im planning on going to my Local Junk yard as well as the Local U-Pull Place. Unless I get lucky to find a piece of RR Track or even an Anvil at a decent price, what could i look for to accomplish getting the right amount of Bounce with my hammer (32oz Estwing) as well as having enough Girth to allow for full strength striking. Im still Learning (Self Taught) so im not 100% concerned with having a Pritchel or Hardy Hole (unless i should be concerned with having one). 

 

Anything will help at this point, Thanks.

Link to post
Share on other sites

Well if you go right over there they have some 4" thick plate that will make a dandy one.   See how helpful it is not to list a starting location?

(It's at the Scrapyard in Polvadera NM)

Have you reviewed the Improvised Anvils thread?  RR rail ranks pretty low compared to most of those. (The Polvadera Scrapyard has a number of 30" and up pieces of rail too.)

 

Link to post
Share on other sites

Sorry I didn't even think to List that, I'm in Gastonia NC. And i haven't seen that thread yet but im going to go through and find it now, thanks for that Tip.

Link to post
Share on other sites
2 minutes ago, Staibsm said:

I'm in Gastonia NC

We won't remember this once leaving this post, hence the suggestion to edit your profile to show it. This thread will help you get the best out of the forum with a lot of tips like how to do the most effective search and how to stay off the moderators radar.:)  READ THIS FIRST -

BTW Welcome aboard.

Link to post
Share on other sites

Not a big thing; it's just that so much of smithing has a general location factor it makes quite a difference if you are in Georgia USA or Georgia near the European/Asian boundary. 

Even in the USA there are multiple Columbus's and Las Vegas New Mexico has been confused with that other one in Nevada at times.

Link to post
Share on other sites

If you were dying for an anvil you could run after a 66lb amazon special. Accacio or something like that? 

 

Otherwise, there are sooo many large pieces of steel on heavy equipment. Behold, 988K bucket pins. 105lb and 115lb. Would make dandy improv anvils.

 

20200227_164801.jpg

20200229_140843.jpg

Link to post
Share on other sites

Join the conversation

You can post now and register later. If you have an account, sign in now to post with your account.

Guest
Reply to this topic...

×   Pasted as rich text.   Paste as plain text instead

  Only 75 emoji are allowed.

×   Your link has been automatically embedded.   Display as a link instead

×   Your previous content has been restored.   Clear editor

×   You cannot paste images directly. Upload or insert images from URL.

×
×
  • Create New...