ablenumbersix

Wagon tongue vise ID

Recommended Posts

Me, I'd just use those two bolts to attach it to a steel block and plate arrangement and bolt it to a rigid table.

 

Chris

Share this post


Link to post
Share on other sites

I saw one where the fellow removed the rear mount entirely, and basically bolted an angle iron section to it and used that to bolt it to a table. 

Share this post


Link to post
Share on other sites

I would fip the section that goes around the wagon tongue so it still attached but pointing down and build a typical post cise  mount for it.  Perhaps with a support that engaged the bottom of the vise for greater strength.

I have a couple of the small vises that look like the top of a post vise but were used on benches; and without a leg on them.

Share this post


Link to post
Share on other sites

Join the conversation

You can post now and register later. If you have an account, sign in now to post with your account.

Guest
Reply to this topic...

×   Pasted as rich text.   Paste as plain text instead

  Only 75 emoji are allowed.

×   Your link has been automatically embedded.   Display as a link instead

×   Your previous content has been restored.   Clear editor

×   You cannot paste images directly. Upload or insert images from URL.