D.IVO

Last Christmas Damascus and other novelties

Recommended Posts

I've been so busy since last year with new job and other experiments that I didnt took take time posting anything so here it goes...

In September 2018 i went to a cutlery expo in Caldas da Rainha, bought a billet of pattern welded steel from Russian knifemaker Kirilov.

 Forged into shape, handle of brazil wood, cherry wood and mosaic pins. It's a joy working with damascus, it was easy to heat treat and the blade is quite hard and though.

 Secound one is forged spring steel, chery wood, pine, mosaic and alluminium pins. Made it for choping and wood working.

 Third one is a choper from file steel, dual temper and S file work . Alluminum guard, brazil wood, leather spacer and oak.

 That small thing with teeth is a broach for hidden tangs, 4mm thick at the end by 12cm long. A very usefull tool I should've made years ago.

Tell me what you think..

 

IMG_20181118_234236.jpg

IMG_20181202_214324.jpg

IMG_20181202_214346.jpg

IMG_20181208_150939.jpg

IMG_20181208_152326.jpg

IMG_20181202_214505.jpg

IMG_20181202_214429.jpg

IMG_20181224_155203.jpg

IMG_20181224_155211.jpg

IMG_20181224_155152.jpg

IMG_20181224_155119.jpg

IMG_20181224_154828.jpg

IMG_20190210_133109.jpg

IMG_20190210_132933.jpg

 

IMG_20190106_211748.jpg

IMG_20190210_133032.jpg

IMG_20190210_133316.jpg

IMG_20190210_133251.jpg

Share this post


Link to post
Share on other sites

There are a couple of things that are good and a few that are not so good.

The Damascus knife came out very well, but why did You made that crude notch?....supposed to be a good hook?...or a false edge?

The file work with the checkering file back ground is a nice, creative  idea, but it should be done before hardening.

Torturing the blade with a gas flame is always a subject of discussion but never good for the blade.

And there are some heavy grooves in the belly of the grip.....they look that You have started doing them but then....?

Even little details need some planning and preparation.....not limiting creativity but controlling the fire of passion.

Remember, less can be more.

Thats a bit of what I think.

 

 

 

 

Share this post


Link to post
Share on other sites

Not a false edge but sharp on both ends. I dont really plan just go with the tide.

File work is all needle files, always before ht and the small grooves are traces of the old file.  I tempered the blade for two hours at ~210 Cº as usual and then I submerge the edge in water for the final temper with the torch , no harm is done and blade is stronger.

The purpose of the grooves is to aid grip nothing more, the polished varnish is a bit slippery when wet .

 

 

 

Share this post


Link to post
Share on other sites

Create an account or sign in to comment

You need to be a member in order to leave a comment

Create an account

Sign up for a new account in our community. It's easy!

Register a new account

Sign in

Already have an account? Sign in here.

Sign In Now