foundryguy

Holland Anvil Block #2

Recommended Posts

I shared a photo in my other thread but thought I would share the new design and details of the shapes. The top left corner is beefed up a bit from the prototype. I am designing a 14 x 14 x 3 block in the coming months as well which will have many more features and a shaping bowl in the center. That block will not have side designs, only holes, squares and slots

11.25 inch x 10 inch x 3 inch thick

Cast holes are smooth and are straight with no draft. Sides have 1 degree draft for molding

Slot is 1.25 inch x 3.25 inch

Rounds are 1 inch, 1.5 inch and 2 inch diameter

Squares are 7/8 inch, 1 inch and 1.5 inch

Exterior 90% Vs are 1.5 inch, 1.75 inch and 2 inch

Exterior rounds are 2 inch, 1.5 inch, 1.25 inch and 1 inch

Exterior Hex is 2.5 inch, 2 inch, and 1.5 inch

These castings are rough cast and can be used as is or after your polish or customization

Material is 65-45-12 ductile iron

duc-2.jpg

Share this post


Link to post
Share on other sites

Join the conversation

You can post now and register later. If you have an account, sign in now to post with your account.

Guest
Reply to this topic...

×   Pasted as rich text.   Paste as plain text instead

  Only 75 emoji are allowed.

×   Your link has been automatically embedded.   Display as a link instead

×   Your previous content has been restored.   Clear editor

×   You cannot paste images directly. Upload or insert images from URL.