Sam Salvati Posted April 22, 2008 Share Posted April 22, 2008 Set of two hammers, and 3 sets of tongs I made for A trade, NOT OFFERED HERE FOR TRADE. 2 sets of bolt tongs one to hold 3/4 round and square, the other to hold 1/4, and a set of flat bar tongs. One cross pein and a smaller version, larger is 1.5 pounds, the smaller is about 1/2 pound. Handles are hickory. Even though that hammer is only 1.5 pounds, it hits HARD. Quote Link to comment Share on other sites More sharing options...
pete46 Posted April 22, 2008 Share Posted April 22, 2008 Sweet Jump'n Start Up Set ! That Is Fine!!!!!!!!!!! Quote Link to comment Share on other sites More sharing options...
Donnie Posted April 22, 2008 Share Posted April 22, 2008 Nice work, Sam. Quote Link to comment Share on other sites More sharing options...
Blacksmith Jim Posted April 23, 2008 Share Posted April 23, 2008 Sam, are you drawing the reins of the tongs out by hand or under a power hammer? Maybe your treadle hammer I guess? Quote Link to comment Share on other sites More sharing options...
Sam Salvati Posted April 23, 2008 Author Share Posted April 23, 2008 No I was too "lazy" to switch out the dies to the drawing set, just drew em out with the 4.4 pounder . Quote Link to comment Share on other sites More sharing options...
simmonds Posted April 24, 2008 Share Posted April 24, 2008 Looks GREAT! Quote Link to comment Share on other sites More sharing options...
Frosty Posted April 24, 2008 Share Posted April 24, 2008 No I was too "lazy" to switch out the dies to the drawing set, just drew em out with the 4.4 pounder . And THAT is why I'll want to come up with a good secure system for quick change dies. I'm PROPERLY lazy, I'll gladly spend many times the effort and time to come up with an "easier" way to do anything. Great looking kits Sam. Frosty Quote Link to comment Share on other sites More sharing options...
Recommended Posts
Join the conversation
You can post now and register later. If you have an account, sign in now to post with your account.