Dan P.

Motor question- VFD or single phase

Recommended Posts

I used a Schneider Electric VFD to start an Anyang 88.  IIRC it was set to start the hammer over a time of about 6-10 seconds.  The only problem was getting the VFD (that model anyway) programmed, finally got a master industrial electrician to do it, the manual was NOT intuitive!  Once set up it worked fine.  Mostly I ran it at the rated speed but sometimes ran it a bit slower just to see if I liked the slower speed.  Never did run it faster but could have.  Sold the hammer with the VFD.

Share this post


Link to post
Share on other sites

Please sign in to comment

You will be able to leave a comment after signing in



Sign In Now