Page76

Finished prepping my anvil

Recommended Posts

Thanks to njanvilman ive been able to identify my anvil and thanks to a bunch of old fashioned elbow grease I've finally got my stand done, my anvil wire wheeled and a nice coat of lindseed oil cooked on.  Even made a nameplate at work for free identifying the anvil in case i kick the bucket so the next guy will know what it is haha.  Tell me what you think. Constructive criticism is welcomed. PS I know the anvil needs to be attached to the stand.  Right now I just have it routed out and set in the pattern.

IMG_20171201_193806508.jpg

IMG_20171201_193020095.jpg

IMG_20171118_113022672.jpg

IMG_20171111_202527406.jpg

Share this post


Link to post
Share on other sites

Nice job! I found that mortising my anvil into the block was plenty secure enough, it didn't bounce, rock or move at all. My mortise was a little deeper, top of the foot and snug. As the block aged and dried out, winters here are VERY dry, think drought dry in the Mojave desert dry. Anyway, when it dried out the anvil loosened up some but was easy to tighten with a couple pieces of flat stock driven in as wedges. 

My new anvil stands are steel tripods with angle iron flange up that fit the anvil foot. I have tong and hammer racks that wedge between the frame and anvil. The steel stands take the damagingly loud ring out of both the Trenton and Soderfors. The rack wedges secure them well enough I can pick either up with the engine hoist and a chain. Hook the anvil and the stand comes along nicely.

Regardless of what I did you get a big thumbs up for a well done piece of work.

Frosty The Lucky.

Share this post


Link to post
Share on other sites

If it were anything other than a Fisher, I'd suggest bedding it down on a layer of silicone caulk, which both secures the anvil to the stand and deadens the ring. Since a Fisher doesn't have much ring to speak of, that's probably not necessary. Instead, I'd go with some nice forged brackets to hold it down.

Share this post


Link to post
Share on other sites

Thank you so much for the kind words fellas!  I've learned a lot by listening to some of the things you guys tell other people. I sure appreciate the professional Insight from you more experienced Smith's!

Share this post


Link to post
Share on other sites

Nice job! My HB is attached to a half inch thick plate on the end of an 8 or 10” I beam with a 2” thick by 12” round plate on the bottom the anvil is 150lb and I’ve never weighed the base but it’s probably also 150lb but it’s very easy to tip it enough to roll it around the shop 

Share this post


Link to post
Share on other sites

Join the conversation

You can post now and register later. If you have an account, sign in now to post with your account.

Guest
Reply to this topic...

×   Pasted as rich text.   Paste as plain text instead

  Only 75 emoji are allowed.

×   Your link has been automatically embedded.   Display as a link instead

×   Your previous content has been restored.   Clear editor

×   You cannot paste images directly. Upload or insert images from URL.