Jump to content
I Forge Iron

Recommended Posts

Okay don't tell no one bahahah 1/8x 1/4  flat bar you need 3 at least 36 inches long ,clamp them to a table or tack , use a torch it helps to have an extra set of hands so you  can keep it tight  ,on the MFC facebook page we have a short video of this process, but here is a ruff sketch I use a cowhide mallet to help flatten it after you finish run it in your forge to tighten it up heat and beat once again thanks to Wayne was a great conference 

20160630_174554.jpg

20160630_174617.jpg

20160630_174705.jpg

Link to post
Share on other sites
  • 3 years later...

Join the conversation

You can post now and register later. If you have an account, sign in now to post with your account.

Guest
Reply to this topic...

×   Pasted as rich text.   Paste as plain text instead

  Only 75 emoji are allowed.

×   Your link has been automatically embedded.   Display as a link instead

×   Your previous content has been restored.   Clear editor

×   You cannot paste images directly. Upload or insert images from URL.

×
×
  • Create New...